E&I laminations
Standard and to-drawing E and I laminations for transformer cores. Standard types are listed on the E&I chart; we make sizes outside it to your drawing.
- Grades
- CRGO, CRNO
- Thicknesses
- 0.23 mm to 0.50 mm
Products
Standard transformer lamination types are listed on the E&I chart. We make everything else to your drawing.
Four families. Open one to see what it covers and what we make it in.
E&I, strip, T&U and segmental laminations for transformer and machine cores.
4 products
Motor stator and rotor stampings, mixer-grinder, pump and fan sets.
3 products
Slit to your width from mother coil up to 1250 mm.
1 product
Transformer laminations cut to length on our own line.
1 product
E&I, strip, T&U and segmental laminations for transformer and machine cores.
Standard and to-drawing E and I laminations for transformer cores. Standard types are listed on the E&I chart; we make sizes outside it to your drawing.
Continuous strip laminations for wound and stacked cores.
T and U core laminations for small transformers and chokes.
Segmental laminations for large-diameter cores, where a full ring would waste material.
Motor stator and rotor stampings, mixer-grinder, pump and fan sets.
Stator and rotor stampings on progressive tooling, with auto-stack and auto-skew where the part calls for it.
Stator and rotor sets for pump and fan motors, in volume.
Universal-motor stampings for mixer-grinders, on tungsten carbide tooling.
Slit to your width from mother coil up to 1250 mm.
Slit to the width you specify, from mother coil up to 1250 mm wide.
Transformer laminations cut to length on our own line.
We cut transformer laminations to length on our cut-to-length line, to your specifications. Up to 400 mm wide.
We slit CRGO and CRNO to the width you specify, from mother coil up to 1250 mm. Every coil is held to the same width tolerance and burr limit, and packed to travel.
A width is a setup rather than a stock item: tell us the width you need and we cut it, and the slit edge is checked for burr before the coil is released.
We cut transformer laminations to length on our cut-to-length line, to your specifications.
The standard mixer-grinder and small-motor designs we tool for. Anything outside this range we make to your drawing.
Our standard design range is being listed. In the meantime, send the design name or a drawing and we will confirm we tool for it.
The grades, thicknesses and coatings we work in. We confirm availability for your part at enquiry.
| Grade | Used for |
|---|---|
| CRGO | Grain-oriented electrical steel for transformer cores. |
| CRNO | Non-oriented electrical steel for rotating machines. |
| CRCA | Cold-rolled close-annealed steel for non-electrical parts of an assembly. |
Send us the drawing with the grade, thickness and monthly volume. If the grade is not settled, say so and we will advise against the application.