Skip to content
Alpine Stampings

Quality

What we check, and when

We inspect at three points in every job. The cadence is the reassurance, not any single measurement.

When we inspect

  1. At every setup

    First-off inspection

    Before we release a run, we inspect the first piece off the tool against your drawing and the tolerances agreed for that part.

  2. During the run

    In-process inspection

    We keep checking while the press is running, so drift is caught inside the lot rather than at the end of it.

  3. Before packing

    Final inspection

    We inspect the finished lot and raise its report before anything is packed.

What we check

The attributes we inspect on a lamination or stamping.

  • Slot concentricity
  • Stack height
  • Burr on punched and slit edges
  • Pitch variation
  • Blanking ID/OD concentricity
  • Overall dimensional conformity to drawing
  • Watt loss on electrical steel
  • Material grade and thickness against the mill certificate
  • Coating condition
  • Surface and visual defects
  • Pack count and lot identity

The quality system

How we govern the checks.

Quality assurance plan and control plan
Held per part, not per factory.
CTQ format
We identify and record the critical-to-quality characteristics for each part.
CAPA
Corrective and preventive action, with the action documented and closed.
Calibration control
We keep our measuring equipment under calibration control.
Drawing and revision control
We make parts to the current revision, and we record the revision.

Certification

We are certified to ISO 9001.

Standard
ISO 9001
Certificate
24EQOS03
Scope
Manufacturing & supply of electrical stampings and magnetic steel laminations
Valid to
October 2027
ISO 9001 certificateDocument to followCapability profile (PDF)Document to follow

What you receive

Mill test certificate
The source mill's test certificate goes out with every despatch.
Finished-goods inspection report
We raise one per lot.
Lot identity
We maintain it through packing.

Request a quotation

Send us the drawing with the grade, thickness and monthly volume. If the grade is not settled, say so and we will advise against the application.

What the part is, or the drawing number it is on.

Optional. A target helps us tell you quickly whether the part is worth tooling.

Up to 10 MB. .pdf, .dwg, .dxf, .step, .stp, .igs, .iges, .png, .jpg, .jpeg, .zip.

We use what you send here to answer your enquiry and for nothing else. Privacy policyDocument to follow