Products
Production process
Six steps, from mother coil to packed pallets.
Six steps
Step 01
Material selection
We match the grade, thickness and coating to the part, and check the coil against its mill test certificate before anything is cut.
Step 02
Slitting
We slit mother coil, up to 1250 mm wide, down to the width the tool needs. We check the slit edge for burr before releasing the strip to the press floor.
Step 03
Press setup
We set the tool in the bolster and set the feed to the strip. Nothing runs until the first-piece is inspected and approved.
Step 04
Stamping
Progressive tooling on presses from 10 T to 220 T. We use auto-stack and auto-skew tooling as per customer requirements.
Step 05
In-process inspection
We keep checking while the press runs, so drift is caught inside the lot rather than at the end of it. What we check at each stage is set out on the quality page.
Step 06
Packing and despatch
We inspect the lot, raise its report and label the crate. Lot identity is maintained through packing, and the mill test certificate goes with the despatch.
Press shop
Power presses from 10 T to 220 T, plus a 400 mm cut-to-length line.
Tooling
Progressive tooling including auto-stack and auto-skew.
Tooling is designed on customer drawings and inspected by us to ensure dimensional accuracy.
Packing
Finished laminations are banded, labelled and palletised so the lot arrives as it left. Lot identity is maintained through packing.
Request a quotation
Send us the drawing with the grade, thickness and monthly volume. If the grade is not settled, say so and we will advise against the application.